Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterGarage Door Before & After in Kyle, TX
Talk is cheap when a 200-pound door is hanging over your car. We’d rather show you what actually happens when we roll up to a house off Rattlesnake Road or down near Plum Creek. The photos below are the kinds of jobs we do every week in Kyle. Same crew, same truck, same owner on the invoice. You can see the difference without us saying a word.
Recent Transformations
Spring Failure on a Clopay Steel Door Near Waterleaf
The homeowner called at 7:15 on a Tuesday morning because the door had slammed down the night before and the car was trapped inside. One torsion spring had snapped, which meant the remaining spring was carrying double the load it was rated for. We replaced both springs as a set, not just the broken one, and checked the cycle count on the drums. The door now lifts with two fingers again, and Otto told them exactly how many cycles are left on the new springs.
Track Alignment After a Kid’s Basketball Got in the Way
A door in the Steeplechase neighborhood had been chewing up rollers for months. The left track was bent inward just enough that the door would shudder halfway up and occasionally pop a roller out of the rail. We pulled the track back to plumb with a come-along, swapped the worn nylon rollers for new sealed-bearing units, and reset the limits on the LiftMaster opener. It runs quiet enough now that the homeowner can hear herself think when she pulls in.
Full Door Replacement for a Wood Rot Problem on a South Kyle Ranch
Kyle heat and the occasional flash flood make short work of untreated wood doors. This one had a bottom panel so soft you could push a thumb through it, and the hinges were pulling out of the frame. We measured the opening, ordered a Wayne Dalton 9100 with 9+ R-value insulation, and had the old door hauled off by the end of the install. The garage stays noticeably cooler now, and the door doesn’t bow when the afternoon sun hits it.
Opener Replacement for a Genie That Gave Up After 18 Years
The old Genie had been grinding for a year before it finally stopped mid-open and left the door hanging four feet off the ground. The circuit board was fried, and a replacement board costs more than the opener was worth. We installed a LiftMaster 84501 with a belt drive, new safety eyes, and a wall console with a motion-sensing light. The owner’s first words after we tested it: “I didn’t know they made them that quiet.”
Off-Track Roller and Cable Repair After a Spring Backup
A door off Goforth Road had jumped the track on one side when the cable snapped. The bottom roller was wedged against the jamb, and the door was cocked at a 15-degree angle. We got the tension off the spring safely, reseated the rollers, replaced both cables as a matched pair, and lubed the hinges and bearings. The door was back in service that afternoon, and we checked the balance twice before we left.
Warped Track and Weather Seal Fix on a North Kyle Corner Lot
Texas sun does a number on exposed tracks. This one had a horizontal rail that had warped enough to bind the carrier trolley, and the bottom seal was so worn that leaves and mulch blew under the door every time the wind picked up. We replaced the track section, leveled the run, installed a new bulb seal, and adjusted the opener limits so the door compresses the seal properly. The garage stays cleaner now, and the door doesn’t sound like it’s dragging a chain.
Want Results Like These?
You don’t have to live with a door that fights you every morning. Call Otto’s Garage Door at (737) 530-9012 and Otto will quote the job on the phone, hold that price at your door, and leave a 90-day written promise on every invoice. Free estimates, no trip charge inside Hays County, and $40 off any repair over $200.
Written by Otto Reinhardt, Owner at Otto’s Garage Door, serving Kyle since 2004.